Welcome Log In Create A New Profile

Advanced

The future of drift boats and river skiffs

Posted by Sandy 
The future of drift boats and river skiffs
August 02, 2018 02:14PM
Fwiw my current direction is bare oiled plywood where (almost) nothing is glued. All parts screw together over either a gasket or a thick bead of roofer's caulk--so any and every part can be replaced.

Has that boat been made? I'm working on it. In traditional framed boats, if a side panel gets hopelessly fractured it's hard to remove if it's been glued to the ribs. If everything goes together with Torx screws everything can come apart. In a jiffy.

After 30 years of fiberglass work I'm heading back to all wood. Or close to it anyway. I might use a little glass here and there.

Change is good. Change is more interesting. I'm interested in decked all-wood boats, with only a few (removable) interior bulkhead partitions. And no ribs'a no kind. The only good ribs are the barbequed kind.

Think about it. Even if you build a low-sided square ended skiff, if it's decked you can still run Yankee Jim Canyon or Whitehorse rapids. It's low so the wind won't torture you on the Deschutes. A decked low-sided skiff could run the Grand Canyon. Tom Martin does it all the time with his little GEM.

Plenty of storage below the deck. Comfortable seats and optional standing/casting braces on top. Open boats don't make sense to me anymore. The original McKenzie boats had high sides so an OPEN boat could run big water. But then they're wind sails. Then they're hard to get into and out of. It just doesn't make sense.

Decked is where it's at. The Dayak convinced me of that.



RDF
Re: Rambling thoughts about the future of drift boats and river skiffs
August 02, 2018 09:01PM
How about a RIB (rigid inflatable boat) river skiff? Or would it RIB river raft? Anyway, same idea as an RIB yacht dingy but the bottom is river skiff profiled. A hard bottom for stiffness but permanently attached inflatable tubes for secondary stability, rock bumping, and reserve buoyancy. The tubes don’t do much of anything in flat water but, they make the boat perform like a raft in big waves.
I’ve been wondering how to go about building that prototype…
Re: Rambling thoughts about the future of drift boats and river skiffs
August 02, 2018 10:05PM
Sounds good. Like a Zodiac River Dory? That would be cool too.



Sorry, only registered users may post in this forum.

Click here to login